Enrolling PG9922 Instruction Guide on IQ Panel 4
Make sure the batteries have been removed from the PG9922.
Put the system into auto learn mode
"Settings>Adv Settings>Installations>Devices>Security Sensor>Auto-learn"
Press and hold down the enroll button (Located next to the battery).
Hold until the LED turns solid, then release
A sensor should show up on the screen of the IQ4 requesting to be added.
Finish the setup and click on "Add New" to complete the enrollment.
Note: If does not get picked up, restart the procedure after holding down the enroll button for 15 seconds to reset the sensor.
Aug 14, 2025