How to enroll the PG9949:
- Put your IQ4 panel in Auto learn. Go to Settings > Advanced Settings > Installer or Dealer Code (1111 or 2222) > Installation > Devices > Security Sensors > Auto Learn.
- Press and hold the disarm button on the wireless key until the LED lights up and as soon as you see the LED release the Disarm button. Do not hold it any longer. Otherwise, the device will not enroll in.
- You will see a page on the IQ4 that says Sensor xxx-xxxx is requesting to be added. Hit okay and follow the instructions on the screen to add the device. Everything can generally be left default. The most common thing installers want to change is the name of the device.
Troubleshooting:
- If the PG9949 does not enroll after using Auto learn, please:
- remove all the batteries again
- take a jumper and short the positive and negative on the PG9949 for 10 seconds on the battery terminal
- the goal here is to discharge the capacitors in the PG9949
- DO NOT TAKE A JUMPER ACROSS THE BATTERIES THEMSELVES.
- Put the batteries back in
- If it still does not enroll you can enroll manually by going to Settings > Advanced Settings > Installer or Dealer Code (1111 or 2222) > Installation > Devices > Security Sensors > Add Sensor. Change the Source on the bottom right to PowerG and then type in the DL ID that is printed on both the box and the sensor.
Aug 14, 2025