How to enroll PGP9934p

Enrolling PG9934P Instruction Guide on IQ Panel 4

1. Make sure the batteries have been removed from the PGP9934P.
2. Put the system into auto learn mode
   1. "Settings>Adv Settings>Installations>Devices>Security Sensor>Auto-learn"
3. Press and hold down the enroll button (Located next to the battery).
   1. Hold until the LED turns solid, then release

1. A sensor should show up on the screen of the IQ4 requesting to be added.
2. Finish the setup and click on "Add New" to complete the enrollment.

Please refer to the Installation Manual for any additional information.

Note: If does not get picked up, restart the procedure after holding down the enroll button for 15 seconds to reset the sensor.