IQ Dimmer PG - Enrollment

Please follow the steps below:

1. Ensure the IQ Panel firmware is compatible ie. 4.4.0 or higher.
2. Enter Advanced Settings in the IQ Panel, and select: “Installation > Devices > Automation > Auto Learn Devices”

   

1. Press and hold both buttons on the IQ Dimmer PG, until the LED turns orange (approximately 2 seconds), then release both buttons.

1. Enter the parameters of the device:     Sensor Name: Select or enter a custom name.     Pin Code: Leave this blank or enter the 8-digit pin code written on the device sticker.     Activation LED: Enable or disable the status LED.

  

Please note that the device LED blinks 3 times once the device is networked with the panel.

Factory reset the device:

1. Press and hold both buttons until the LED turns orange (approximately 2 seconds).
2. Release both buttons.
3. Press and hold both buttons again until the LED turns red (approximately 5 seconds), the LED will flash 3 times.
4. Release both buttons.

Note: if the device was enrolled into an IQ Panel during the reset, it will need to be re-enrolled after the reset.