IQ Outdoor Plug PG - Enrollment

Please follow the steps below to enroll:

1. Ensure the IQ Panel firmware is compatible i.e., 4.4.0 or higher.
2. Enter Advanced Settings in the IQ Panel, and select: “Installation > Devices > Automation > Auto Learn Devices”

  

1. Press and hold both buttons on the IQ Outdoor Plug PG, until the LED turns orange (approximately 2 seconds), then release both buttons.

Note: If the IQ Outdoor Plug PG is not already plugged in at the time of enrollment, plugging it in will automatically broadcast the Power G ID to the panel after a few seconds).

1. Enter the parameters of the device:

Sensor Name: Select or enter a custom name.
    Pin Code: Leave this blank or enter the 8-digit pin code written on the device sticker.
    Activation LED: Enable or disable the status LED.

  

Note: This device enrolls as two separate automation devices.

This means you can individually edit the devices parameters (such as device name), as well as control the outlets individually on the IQ Panel, IQ Remote and through Alarm.com.