QOLSYS Logo

IQ WIFI 6 - 2.0.2 SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS

TSB #: 231707
DATE: 07/17/23
RE: IQ WIFI 6 - 2.0.2 SOFTWARE UPDATE
RELEASE NOTES & UPDATE INSTRUCTIONS

Release Notes:



New Features:
• Added setting to enable/disable allowing available DFS channels in auto-channel selection. By default, DFS
channels may be selected by IQ WiFi 6 if permissible and offering the best performance in your area. However,
some Roku streaming TV devices are not capable of using DFS channels and may instead use the 2.4 GHz WiFi band if a DFS channel is selected. The setting can be altered through the router web UI or configured to be
automatically set using the ADC dealer portal to allow or disallow DFS channels.
• Improved compatibility with the Alarm.com POE to WiFi Bridge (ADC-W110). Resolved an issue where the
W110 and associated camera would sometimes fail to reconnect during a power restoral after an outage.

Fixes/Improvements:
• Other performance, security, and reliability improvements.



Update Instructions:
By default, all IQ WiFi 6 routers ship from the factory with auto-update enabled and will automatically update to
v2.0.2 in the days following the release. When auto update is enabled, IQ WiFi 6 automatically checks each night
for updated software and, if available, downloads it to local storage. The following night the software update is
automatically applied to the mesh. If this behavior is not desired, auto-update to 2.0.2 can be disabled through
the web admin UI by toggling the “Auto Upgrade” selection and clicking the “Save and Apply” button. If an “Auto
Upgrade” selection has been deselected the update can be achieved by patchtag.

After 2.0.2 is published to upgrade via patchtag, validate IQ WiFi 6 is connected to the internet and from a web
UI enter the gateway address: 192.168.105.1. Username: admin. The default Password: located on the bottom of
each IQ WIFI 6. Proceed to the SYSTEM tab and touch FIRMWARE UPDATE. Find the Patchtag Update section
and enter in the patchtag: iqwifi2.0.2 Next, touch the Upgrade button. Updates can take as long as 15 minutes
and will reboot once complete.

Contact Us

Not finding what you're looking for? Contact Us Directly