Enrolling PowerG 3-way Dimmer.
- Before starting the enrollment, make sure the switch has power (Confirm by turning on and off the switch)
- Start the enrollment by going to "Settings>Advance Settings>Installations>Devices>Automation>Auto Learn Devices"
- Press and hold UP and DOWN button for 2 seconds and release.
- Check the screen at the panel and confirm the enrollment.
Note: If the device does not get recognize by the panel please perform the following to reset the sensor
- Press and hold both UP and DOWN button for 2 seconds or until the orange LED comes out.
- Press and hold again for 5 seconds and the LED should flash red 3 times indicating the sensor has been reset.
A trained electrician is recommend for hardware installation.
Sep 8, 2025