IQ Power Switch- PG (3-Way)

Enrolling PowerG 3-way Switch.

  1. Before starting the enrollment, make sure the switch has power (Confirm by turning on and off the switch)
  2. Start the enrollment by going to "Settings>Advance Settings>Installations>Devices>Automation>Auto Learn Devices"
  3. Press and hold ON and OFF button for 2 seconds and release.
  4. Check the screen at the panel and confirm the enrollment.

Note: If the device does not get recognize by the panel please perform the following to reset the sensor

  1. Press and hold both ON and OFF button for 2 seconds or until the orange LED comes out.
  2. Press and hold again for 5 seconds and the LED should flash red 3 times indicating the sensor has been reset.

A trained electrician is recommend for hardware installation.

Sep 8, 2025