IQ4/IQ4 Hub : PowerG remote pairing over WiFi /PowerG

IQ Remote PowerG:
Enrollment over Wi-Fi:

  • Use the following steps to enroll an IQ Remote Power G over Wi-Fi
  • Step 1:  Power up the IQ Remote.
  • Step 2: Select the desired Wi-Fi network’s SSID and enter the corresponding password (if required).
    • This pairs the IQ Remote to the home Wi-Fi network (ensure the IQ Panel is also connected to the same network).
  • Step 3: On the IQ 4/IQ 4 Hub panel:
    • Navigate to: Settings > Advance Settings > Enter Installer (1111) or Dealer (2222) Code > Installation > Devices > Wi-Fi Devices > IQ Remote Device, then select “Pair”.
  • Step 4: On the IQ Remote Power G, press the “WIFI Pair” button to pair over Wi-Fi.

IQRPG.jpg

  • Note: You may notice that the IQ Remote Power G begins a firmware update, this will always occur when the IQ Remote Power G is using an outdated firmware as firmware updates are always pushed from the IQ Panel to the IQ Remote Power G automatically.
  • The IQ Remote Power G will reboot after updating.
  • Now the IQ Panel will show an IQ Remote Power G paired with the system, pressing the edit button allows you to change parameters.

Enrollment over PowerG:

  • Use the following steps to enroll an IQ Remote Power G over Power G
  • Step 1:  Power up the IQ Remote.
  • Step 2: Ignore the Wi-Fi connections on the left, as we are not going to use that.
  • Step 3: On the IQ 4/IQ 4 Hub panel:
    • Navigate to: Settings > Advance Settings > Enter Installer (1111) or Dealer (2222) Code > Installation > Devices > Security  Sensors > Auto Learn Sensor.
  • Step 4: On the IQ Remote Power G, press the “PowerG Pair” button to pair over Power G.
  • The panel will now show the enrollment parameters including the Power G ID, Sensor Name and the ability to enable/disable voice prompts.
  • Step 5: Select “Add New”.
  • Note: You may notice that the IQ Remote Power G begins to enroll and may take a few moments to complete. The IQ Remote Power G will reboot after updating.
  • Now the IQ Panel will show an IQ Remote Power G paired with the system, pressing the edit button allows you to change parameters.

IQRPG3.jpg

Firmware Upgrades

  • It is highly recommended to check for firmware upgrades immediately after enrollment.
  • Firmware upgrades can be performed by patch tag, or blank tag.
    • Note: Updates can be performed while connected with Wi-Fi
  • To perform an update while connected to the panel with Power G:
  • The IQ Remote Power G must be within range of the IQ Panel’s access point (within 20 feet).
    • Note: the panel automatically enables the panel access point in this situation.iqrpg4.jpg
May 2, 2025